After Kick-Ass' insane bravery inspires a new wave of self-made masked crusaders, led by the badass Colonel Stars and Stripes, our hero joins them on patrol. When these amateur superheroes are hunted down by Red Mist -- reborn as The Mother F%&*^r -- only the blade-wielding Hit Girl can prevent their annihilation. When we last saw junior assassin Hit Girl and young vigilante Kick-Ass, they were trying to live as normal teenagers Mindy and Dave. With graduation looming and uncertain what to do, Dave decides to start the world's first superhero team with Mindy. Unfortunately, when Mindy is busted for sneaking out as Hit Girl, she's forced to retire-leaving her to navigate the terrifying world of high-school mean girls on her own. With no one left to turn to, Dave joins forces with Justice Forever, run by a born-again ex-mobster named Colonel Stars and Stripes. Just as they start to make a real difference on the streets, the world's first super villain, The Mother F%&*^r, assembles his ... Written by Universal Pictures
The device irradiates samples with alpha particles and maps the spectra of X-rays that are re-emitted for determining the elemental composition of samples.  Curiosity 's APXS was developed by the Canadian Space Agency .  MacDonald Dettwiler (MDA) , the Canadian aerospace company that built the Canadarm and RADARSAT , were responsible for the engineering design and building of the APXS. The APXS science team includes members from the University of Guelph , the University of New Brunswick , the University of Western Ontario , NASA , the University of California, San Diego and Cornell University .  The APXS instrument takes advantage of particle-induced X-ray emission (PIXE) and X-ray fluorescence , previously exploited by the Mars Pathfinder and the Mars Exploration Rovers .  
One thing I was careful to do is not put quite as much resin as I had last time. Because I was working too fast yesterday, for fear the heat would build up too much and kick off the lamination, I did not brush out the resin as well as I could. This made the resin flow around the edge of the plastic wrap and made it difficult to remove. It took time to get the little imbedded threads of hardened resin out. I also had to sand some of the thin resin strands. Before I put this last layer on I brushed the mast with resin so it would flow in the little pits that were left once the edge of the shrink wrap were removed.